![]() ![]() The spring and hammer are under a little pressure but not too much, in any case remove these parts. Next remove the trigger/safety (don't loose the detent ball for the safety) and rear retaining cap. Then remove the two roll pins that hold the muzzle cap inplace and bring the piston/rod back far enough to line up the pump handle pin with the lower muzzle cap hole and remove that pin. ![]() Start by removing the stock screw and stock. After ordering an RWS 34 to play with I came across a rebuild kit from Pyramyd air that cost about $28 including the special tool to take them apart (I was quoted $100 to rebuild it years ago). 22 cal air rifle when I was 11 but it has been dead for years due to worn out parts. The first gun given to me was a Benjamin.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |